FEC MICRO NR - Manual (Page 7)

Do not remove the motors and gear cases of tools while power is applied..
The tool output spindle may rotate and cause injury.
Do not repair, disassemble, or modify the equipment individual components of the system.
Failure to observe this instruction may cause injury, electric shock, fire, and malfunction.
Never operate the equipment where it is exposed to water, near a corrosive atmosphere or
flammable gases. Failure to observe this instruction may cause fire.
Keep fingers away from the connectors while the equipment is turned ON and for a while after
the equipment is turned OFF. Failure to observe this instruction may cause electric shock.
Wiring operation and maintenance work shall be conducted by a qualified professional.
Failure to observe this instruction may cause electric shock and injury.
Turn OFF the power when conducting wiring operation and maintenance.
Failure to observe this instruction may cause electric shock and injury.
Never damage the cables, apply excess stress to cables, or squeeze the cables.
Never use damaged cables. Failure to observe this instruction may cause electric shock and
fire.
Conduct type-3 grounding of FG terminals.
Failure to observe this instruction may cause electric shock.
In case of an abnormal odor, noise, or operation error occurrence, stop operation immediately
and turn OFF the power source. Failure to observe this instruction may cause injury and fire.
Install a Power shutdown device in order to ensure the safety of equipment.
Failure to observe this instruction may cause injury.
Install an emergency stop circuit on the outside of equipment in order to stop operation
promptly. Failure to observe this instruction may cause injury.
Keep away from the equipment during recovery from a temporary blackout, and ensure safety
measures are conducted after restarting the equipment. The equipment may suddenly restart.
Failure to observe this instruction may cause injury.
Warning
Safety Precautions