FEC MICRO NR - Manual (Page 88)

Chapter 7: System Operations
Page 7-20
7.3.3 Parameter Setup Confirmation
When the data is changed, the [DATA] display will show "CHNG," and the D-NO display will show
"NO." Use the vertical arrow buttons to choose YES or NO; YES means that the data will be
entered if the confirmation SET button is pressed. The [SET] and [MODE] buttons will have no
effect when "NO" appears.
If neither “Yes” nor “No” is selected within 4 seconds, the new data will be ignored and
the system will exit the Data Edit Mode.
If the [MODE] button is pressed when the cursor (blinking digit) is at the right-most digit
in the [DATA] display, the new data will be ignored and the system will exit the Data Edit
mode.
If Power is turned off to the system while in Data Edit Mode, the new data will not be
stored.
MODE 

SET
Parameter update