FEC MICRO NR - Manual (Page 11)

Table of Contents
Page
Chapter 1: Outline 1-1
1.1 About This operations manual 1-2
1.2 Features 1-3
1.3 Functions 1-5
1.4 System requirements 1-7
Chapter 2: Specifications 2-1
2.1 Main Specifications 2-2
2.2 Duty Cycle Calculation 2-3
2.3 SAN Unit Specifications 2-4
2.4 Capability. 2-5
2.4.1 Nutrunner Tool Specification Table 2-6
Chapter 3: System Description 3-1
3.1 System Block Diagram 3-2
3.1.1 System Block Diagram Description 3-2
3.2 Micro-NR MNR UNIT Front panel 3-3
3.2.1 MNR Front Panel Switches and Connectors 3-3
3.2.2 MNR Status LED 3-4
3.3 Micro-Nr Keyboard-Display description 3-5
3.3.1 MNR Serial Pin out 3-5
3.3.2 MNR Communication Protocol 3-6
3.3.3 MNR Communication Format 3-6
3.3.4 MNR Communication Format Description 3-7
3.3.5 Cable Connection to MNR Unit 3-8
3.4 Micro-NR (Tool) Unit 3-9
Chapter 4: System Setup and Wiring 4-1
4.1 Component Dimensions 4-2
4.1.1 MNR Controller Unit Dimensions 4-2
4.1.2 Micro-NR Tool Dimensions 4-3
4.2 Power Requirements and Connections 4-4
4.2.1 MNR Unit 4-4
4.3 Wiring PLC I/O 4-6
4.3.1 Explanation of MNR Unit I/O 4-7
4.3.2 Work / Parameter Select Table 4-8
4.3.3 PLC Wiring Sample 4-9
4.4 Signal Timing Chart 4-11
4.5 USB Communication Port 4-12
4.6 MNR Unit DIP Switch setting. 4-13
4.6.1 MNR Unit DIP SW1 settings 4-14
4.7 Tool Connection (cabling) 4-15
4.7.1 Cable Installation Guidelines 4-16
4.7.2 Considerations for Cable Trolleys 4-17
4.7.3 Considerations for Flexible Cable Tracks 4-17
4.7.4 Considerations for Cable Trays and Ladders 4-17
4.12 Firmware Flash Connector (CN8). 4-36