FEC MICRO NR - Manual (Page 102)

Chapter 8: System Operations
Page 8-6
8.3.2 Replace Nutrunner (tool).
Do not attempt to replace a component of the tool - the tool must be replaced as a complete as-
sembly. The tool type identification can be found on the identification tag affixed to the tool and
on the System [TOOL TYPE] preset value.
1. Verify all System power is off.
2. Ensure that the homerun cable is marked for reconnection, then disconnect it from the tool.
3. Ensure the spindle assembly is supported, and remove the two (4) bolts securing it to the
mounting plate.
4. Follow all safety precautions to install an identical nutrunner assembly by performing the
removal procedure in reverse order.
8.3.3 Replace homerun cables
FEC INC. recommends purchasing a spare homerun cable with each System.
1. Verify all System power is off.
2. Disconnect the damaged cable from the nutrunner and the MNR unit and replace with the
spare cable.