FEC MICRO NR - Manual (Page 115)

FEC Micro Nutrunner Operations Manual Chapter 9: Troubleshooting (Rev. 2: 02/12)
Page 9-13
9.9 Parameter Error
9.9.1 Code 9-0 PARAMETER ERROR / MISSING SPEED PRESET
Some speed preset is not setup in the parameter number selected or the wrong parameter
number has been selected by the PLC.
RECOVERY:
1. Verify that the parameter number that is being selected by the PLC is configured in the
controller.
2. Check that the reverse speed preset is not <0> or out of the specified speed range of the
tool .
9.9.2 Code 9-1 PARAMETER ERROR / MISSING TIME or SPEED PRESET
Some Time or Speed preset is not setup in the parameter number selected or the wrong
parameter number has been selected by the PLC.
RECOVERY:
1. Verify that the parameter number that is being selected by the PLC is configured in the
controller.
2. Check that the reverse speed preset is not <0> or out of the specified speed range of the
tool .
9.9.3 Code 9-2 PARAMETER ERROR / PARAMETER SELECT ERROR
The parameter selected was empty.
RECOVERY:
1. Verify that the parameter number that is being selected by the PLC is configured in the
controller.
2. Check that the fastening presets are not <0> or out of the specified range for the tool.
9.9.4 Code 9-3 PARAMETER ERROR / MISSING REVERSE SPEED
The Reverse Speed preset is missing.
RECOVERY:
1. Verify that the parameter number that is being selected by the PLC is configured in the
controller.
2. Check that the reverse presets are not <0> or out of the specified range for the tool.
9.9.5 Code 9-4 PARAMETER ERROR / TORQUE SPEED NOT SET
The Torque Speed preset is missing.
RECOVERY:
1. Verify that the parameter number that is being selected by the PLC is configured in the
controller.
2. Check that the Torque speed is not set as <0> or out of the specified range for the tool.