Micromod Micro-DCI: 53MT6000 Micro-Tools - Manual (Page 74)

53MT6000 INSTRUCTION MANUAL
58 Database Editor
SP Track Enable: This parameter is used in conjunction with the Setpoint
Track Switch to select the Setpoint Track Mode. The
control module’s setpoint is forced to track the Setpoint
Track Value when the Setpoint Track Status is 1. Available
selections [L118]:
Tracking Disabled
Tracking Enabled
Setpoint (Change): A setpoint change here only takes effect if the Controller is
in LOCAL mode [C101].
Remote SP Bias: This parameter and the Remote Setpoint Ratio are used to
modify the remote setpoint prior to its use by the control
module [C112].
Remote SP Ratio: This parameter and the Remote Setpoint Bias are used to
modify the remote setpoint prior to its use by the control
module [C113].
Setpoint Slew Rate: This parameter is used to control the rate of change limit on
the Setpoint [C117].
Setpoint High Limit: High setpoint limit value [C125].
Setpoint Low Limit: Low setpoint limit value [C126].
OK: Saves changes, closes window and returns to main menu.
Save: Saves changes without closing window.
Cancel: Cancels changes and returns to main menu.
ENTRY EXPLANATION