Micromod Micro-DCI: 53MT6000 Micro-Tools - Manual (Page 71)

53MT6000 INSTRUCTION MANUAL
Database Editor 55
7.4.7.2 OUTPUT Configurable Parameters
The control module OUTPUT parameters may be configured by clicking on the OUTPUT button. The win-
dow shown in
Figure 7-11 will be displayed. The database locations where these values are stored for
CON0 are shown in brackets [ ].
Auto Enable: Available selections [L114] :
Auto Disabled
Auto Enabled
Manual Fallback
Disable: Available selections [L120]:
Fallback Enabled
Fallback Disabled
Process Variable: Displays Process Variable value
Setpoint
(Change): A setpoint change here only takes effect if controller is in
LOCAL mode [C101]
Output (Change): An output change here will only take effect if the controller
is in MANUAL mode [C102]
Controller Span: Full scale range in engineering units [C115]
Controller Lower
Range: Low range value in engineering units [C116]
OK: Saves changes, closes window and returns to main menu
Save: Saves changes without closing window
Cancel: Cancels changes and returns to main menu
Figure 7-11. Output Parameter Configuration Window
ENTRY EXPLANATION