Micromod Micro-DCI: 53SL6000 Single Loop Controller - Manual (Page 65)

• Figure 7-15. Manual Output Path
•
Figure 7-16. Auto Digital Output Path
7.5 Signal Paths for the in.Ld
Control Scheme
The indicator/loader (in.Ld) control scheme paths
are depicted in Figures 7-17 through 7-20. The
hexagons in the figures are the control signal out-
puts from Figure 7-2. They enable analog signal
switch paths that affect operation of the control
scheme. Other analog signal switches are con-
trolled by the conF-cn.1 module parameters, which
are depicted as circled inputs; and the ProG-cS
module parameters, which are depicted as dia-
mond inputs. Unless specifically required by the
example, the parameter path settings are arbitrary
(e.g., rSV can be set for direct [dir] or reverse
[rEV]). The in.Ld control scheme path figures are
as follows:
•
Figure 7-17. in.Ld Control Scheme Alarmed
Variable Input
• Figure 7-18. in.Ld Control Scheme Auto
Input with Digital Output
•
Figure 7-19. in.Ld Control Scheme Output
Tracking
• Figure 7-20. in.Ld Control Scheme Manual
Output
Section 7. Control Scheme Block 53SL6000 Instruction Manual
7-7