B&K Precision 2516 - Manual - Manual (Page 89)

89
4.
Press
to enter the Utility Menu and press to go to
page 3/4 of the menu.
5.
Select Update Firmware by pressing .
6.
To proceed, press
. Otherwise, press to exit out
of the firmware update menu.
7.
From the Directory menu, use the
and arrow
keys to select the firmware file stored in the USB flash drive.
8.
Once selected, select Load by pressing
.
9.
At this point, the instrument will begin updating the firmware.
WARNING:
Do not power off the instrument or press any of the
front panel keys at any time during the update
process. Any power interruption or key press
interruption may damage the instrument or corrupt
the firmware, causing it to malfunction and void the
warranty.
10.
Wait for 1-2 minutes for the update to finish. A progress bar on the
display will indicate when update is complete.
11.
When finished, a prompt will say “Update Successfully” and will
prompt the user to reboot the instrument.
12.
At this point, power off the instrument by holding down
for at
least three seconds, then power back on again.
13.
To verify that the instrument has updated successfully, press
to go to the Utility menu and press from page 1 of the
menu to select System Status.