B&K Precision 2516 - Manual - Manual (Page 127)

127
Record Data with Trend Plot
Follow these steps to record data using Scope Trend Plot.
1.
Select the type of data you want to record.
Press to select Param A option, and a submenu similar to
the Measure menu will display.
2.
Select between voltage, time, or delay measurement parameters.
Press to choose from voltage measurement parameters.
Press to choose from time measurement parameters.
Press to choose from delay measurement parameters.
3.
Select the source channel and type of measurement parameter you
want to record.
For voltage measurement parameters, the menu and selections are
the same as in “Table 37 - Voltage Measurement Parameters Menu”.
For time measurement parameters, the menu and selections are the
same as in “Table 38 - Time Measurement Parameters Menu”.
For delay measurement parameters, the menu and selections are
the same as in “Table 39 - Delay Measurement Parameters Menu”.
4.
After selecting, press
to select Confirm. This will take you
back to the Scope Trend Plot menu. In the menu below Param A, it
will now show the new measurement parameter for recording.
If you are recording a different measurement parameter than what
was previously selected, a confirmation message will be displayed to
ask if you want to clear all data that are temporarily stored in
memory before recording the new measurement parameter. Press