B&K Precision 2516 - Manual - Manual (Page 41)

41
Table 3 - Channel Menu 2/2
Menu
Option
Setting Description
Invert
On
Off
Enable/Disable waveform invert function.
Filter Enter the FILTER menu.
To Zero
Set waveform vertical position and trigger level to
zero.
Next
Page
Page 2/2 Return to the first page of CH1/CH2 menu.
Channel Coupling
Both channel 1 and channel 2 coupling can be set to DC, AC, or GND
(ground). Press
in the channel menu to toggle the settings.
Bandwidth Limit
Bandwidth limit can be enabled or disabled by toggling
in the
channel menu. When enabled, there will be a B indicator next to the
channel indicator below the bottom left corner of the oscilloscope
waveform display area.
Vertical Scale
The vertical scale control adjustment can be set for coarse or fine control.
Press the button in the channel menu to toggle between Coarse
and Fine.
Probe Attenuation Scale
The voltage/division display scale can be changed to match the attenuation
factor on the oscilloscope probe. To change this, press the button