B&K Precision 2516 - Manual - Manual (Page 42)

42
in the channel menu to select and change the Probe setting. As you change
this setting, the volt/div scale indicator will also change based on the
attenuation factor selected.
Invert Waveform
The oscilloscope can display the inverted signal of the input waveform on
channel 1 and channel 2. To enable this, press from the channel
menu to go to the second menu page, and press to toggle Invert
between On and Off.
Digital Filter
There are four types of digital filters available and can be used to apply to
the input waveform. To access the digital filter menu, go to page two of the
channel menu and press to enter the filter menu. Below is a table
of the filter menu structure.
Table 4 - Digital Filter Menu
Option Setting Description
Digital Filter
On Turn on the digital filter.
Off Turn off the digital filter.
Type
Setup as LPF (Low Pass Filter).
Setup as HPF (High Pass Filter).
Setup as BPF (Band Pass Filter).
Setup as BRF (Band Reject Filter).
Upp_Limit
Use the up and down arrow keys to set
upper limit.
Low_Limit
Use the up and down arrow keys to set
lower limit.
Return Return to the CH1 or CH2 menu.