EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 53)

5.9.4. Ways to Load Trains
You can load a record train by dragging and dropping the train from one of the following
locations to the Player:
• from the Browser in IPEdit (from the Clips grid)
• from the Database Explorer (from the Clips grid)
• from the Channel Explorer
• from the History list of a Control Panel
5.9.5. Ways to Load Logs
When a log is dragged to the Player, this loads either the protect media clip or the
associated record train (if still available on the server).
If no protect media or associated train exists, the log cannot be loaded to the Player.
You can load logs by dragging and dropping them from one of the following locations to the
Player:
• from the Browser in IPEdit (from the Logs grid)
• from the Database Explorer (from the Logs grid)
• from IPLogger
5.9.6. Changing the Camera Angle
Clip Loaded on the Player
When a clip is loaded on the Player and belongs to a group of linked clips, you can easily
load the linked clips as follows:
• Press to load the previous linked clip at the same TC.
• Press to load the next linked clip at the same TC.
Record Train Loaded on the Player
When a record train is loaded on the Player, you can select another recorder on the XNet
network. This record train will be loaded on the same TC as the previously loaded record
train:
• Change on the fly by right-clicking the button and select the requested recorder
channel.
IPDirector - Version 6.2 - User Manual - IPEdit
5. Player 41