EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 42)

◦ Timecode
◦ Timecode and date
2. Select one of the options.
5.5.3. How to Create a Clip Based on the Loaded
Media
By double-clicking the media in the Browser, you will load the media to the Player.
To create a clip based on the loaded media, proceed as follows:
1. Browse through media to select the point to be marked IN.
2. Create an IN point in one of the following ways:
◦ Use the clip creation function to set an IN point at the required timecode.
◦ Enter the timecode of the requested IN point in the IN field and press ENTER.
The IN point is set:
3. Create an OUT point in one of the following ways:
◦ Use the clip creation function to set an OUT point at the required timecode
◦ Enter the timecode of the requested OUT point in the OUT field and press
ENTER.
The OUT point is set:
The clip duration is displayed in the Duration field.
4. Save the clip by clicking the SAVE button or the corresponding shortcut.
◦ If the Show Save Clip Window setting has not been enabled in the Tools >
Settings > Clips > General category, the clip is saved according to the settings
defined in the Tools > Settings > Autoname category.
The procedure is finished.
◦ If the Open Save Clip Window setting has been enabled, the Save Clip window
will open. For more information, refer to section "Save Clip Window" in the Control
Panel chapter.
Follow steps 5 and 6.
5. Fill in a clip name and any desired information in the Save Clip window.
6. Click the Save button.
The new clip is created and added to the Browser.
30 5. Player
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A