EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 199)

◦ For a mute, click in the matrix on the bullet located on the line of the output
channel to mute.
5. If you want to apply the swap between a mark IN and mark OUT points, tick the
Apply between mark IN and mark OUT check box.
In this case, you can overwrite existing swap/mute between these points by ticking
the Overwrite existing swap/mute check box.
6. If you want to define a mix effect at the start and end of the swap, specify the duration
of the effect in the Swap mix duration spin box.
7. Click Apply.
The swap and mutes are defined on the requested part of the audio track.
This is symbolized with the swap icon or the mute icon displayed on the relevant
elements in the general display of the timeline.
The swaps and mutes can be viewed on the Swap/Mute Zoom display:
6.13.9. Modifying Audio Swaps
How to Modify a Swap or Mute on one or More
Elements of an Audio Track
To modify a swap or mute defined on one or more elements of an audio track, proceed as
follows:
1. In the general timeline display, select the elements of a track on which you want to
modify the swap. For a multiple selection, select the elements while pressing CTRL.
2. Right-click one of the selected elements and select Modify Swap/Mute.
The Swap/Mute Configuration window opens with the parameters defined on the first
swapped element of the selection.
3. Do one of the following to modify or add a swap or mute:
◦ For a swap, click in the matrix at the intersection between the source channel to
play and the output channel on which the source should be played.
◦ For mute, click in the matrix on the bullet located on the line of the output channel
to mute. If you click again, the bullet reappears and the channel is no longer
muted.
4. Repeat the step 3 on all the channels that you want to swap or mute.
5. Click Apply.
The selected swaps or mutes are modified according to the new settings.
IPDirector - Version 6.2 - User Manual - IPEdit
6. Timeline 187