EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 198)

How to Add a Swap or Mute From and to Given
Points of a Track
To add an audio swap or mute from and to given points of an audio track, proceed as
follows:
1. In the general timeline display, click the Swap/Mute Zoom button on the right of
the track on which to add the swap or mute.
The track is displayed in Swap/Mute Zoom mode.
2. Do one of the following to specify the start and end point of the swap:
◦ Place a mark IN at the start point and a mark OUT at the end point.
◦ Place the nowline at the start point if you want the end point to be the end of the
element.
3. Right-click after the nowline or between the mark IN and mark OUT points and select
Add Swap/Mute.
The Swap/Mute Configuration window opens:
4. Do one of the following to define a swap or mute:
◦ For a swap, click in the matrix at the intersection between the source channel to
play and the output channel on which the source should be played.
186 6. Timeline
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A