EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 164)

6.11.5. How to Slide an Element Using the
ShuttlePRO
To slide one or more elements of the same source media using the ShuttlePRO, proceed
as follows:
1. Activate the slide mode on the requested elements by lassoing the whole elements
from right to left, keeping the CTRL key pressed.
See section "Activating and Deactivating the Slide Mode" on page 149.
->
2. Click the requested Timeline Track Selection buttons to select or unselect the
tracks you want or do not want to slide.
3. Rotate the jog to the left or to the right to slide the elements respectively to the left or
to the right.
When you stop turning the jog, the slide action is applied within 1 sec.
4. Click anywhere in the Lasso Selection area to leave the slide mode.
6.12. Transition Effects
6.12.1. Introduction
Principles and Limitations
In IPEdit, the transition effects follow the principles below:
• Effects can be added on the transitions of the audio and video elements of any
timeline track.
• They can be heard and seen when browsing the timeline.
• A transition effect is always linked to the beginning of the element.
• It is possible to perform transitions from and to mute or blank elements.
• The video and audio transition effects can have a different duration.
• The transition effect will not impact the duration of the element as it is created beyond
the IN or OUT points of the element, using the material available in the guardbands or
on the record train.
152 6. Timeline
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A