EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 200)

How to Modify a Swap or Mute Defined From and
to Given Points of a Track
To modify an audio swap or mute defined on a part of an audio track, proceed as follows:
1. In the general timeline display, click the Swap/Mute Zoom button on the right of
the track on which to add the swap or mute.
The track is displayed in Swap/Mute Zoom mode.
2. Select the swaps you want to modify in one of the following ways:
◦ Lasso the swap point(s) to select from right to left.
◦ Right-click the swap point(s) to select, keeping CTRL pressed for multiple
selections.
3. Right-click and select Modify Swap/Mute.
The Swap/Mute Configuration window opens.
4. Do one of the following to modify or add a swap or mute:
◦ For a swap, click in the matrix at the intersection between the source channel to
play and the output channel on which the source should be played.
◦ For mute, click in the matrix on the bullet located on the line of the output channel
to mute. If you click again, the bullet reappears and the channel is no longer
muted.
5. If you want to define a mix effect at the start and end of the swap, specify the duration
of the effect in the Swap mix duration spin box.
6. Click Apply.
The swap and mutes are modified according to the new settings.
6.13.10. Deleting Audio Swaps
How to Delete a Swap or Mute on one or More
Elements of an Audio Track
To delete a swap or mute defined on one or more elements of an audio track, proceed as
follows:
1. In the general timeline display, select the elements of a track on which you want to
delete the swap. For a multiple selection, select the elements while pressing CTRL.
2. Right-click one of the selected elements and select Delete Swap/Mute.
3. Answer Yes to the message asking whether you want to delete the swaps or mutes.
The selected swaps or mutes are deleted.
188 6. Timeline
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A