5 delete vlan id, 6 enable vlan, 7 disable vlan – ZyXEL Communications GS-3012F Series User Manual
Page 263: 8 show vlan setting, Figure 166 no vlan command example
Chapter 34 IEEE 802.1Q Tagged VLAN Commands
GS-3012/GS-3012F User’s Guide
263
Untagged Frames
1 An untagged frame comes in from the LAN.
2 The switch checks the PVID table and assigns a temporary VID of 1.
3 The switch ignores the port from which the frame came, because the switch does not
send a frame to the port from which it came. The switch also does not forward frames to
“forbidden” ports.
4 If after looking at the SVLAN, the switch does not have any ports to which it will send
the frame, it won’t check the port filter.
34.5.5 Delete VLAN ID
Syntax:
no vlan
This command deletes the specified VLAN ID entry from the static VLAN table. The
following example deletes entry 2 in the static VLAN table.
Figure 166 no vlan Command Example
34.6 Enable VLAN
Syntax:
vlan
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.
34.7 Disable VLAN
Syntax:
vlan
This command disables the specified VLAN ID in the SVLAN (Static VLAN) table.
34.8 Show VLAN Setting
Syntax:
show vlan
This command shows the IEEE 802.1Q Tagged SVLAN (Static VLAN) table.
where
=
The VLAN ID [1 – 4094].
sysname(config)# no vlan 2