ZyXEL Communications GS-3012F Series User Manual
Page 235
Chapter 32 Introducing the Commands
GS-3012/GS-3012F User’s Guide
235
name
Sets a name for your interface. Enter a
descriptive name (up to nine printable
ASCII characters).
13
no
bandwidth-limit
cir
Disables CIR bandwidth limits on the
port(s).
13
bandwidth-limit
egress
Disables egress bandwidth limits on the
port(s).
13
bandwidth-limit
pir
Disables PIR bandwidth limits on the
port(s).
13
broadcast-limit
Disables broadcast storm control limit
on the port(s).
13
dlf-limit
Disables destination lookup failure
(DLF) on the port(s).
13
egress set
Disables the outgoing traffic port list for
a port-based VLAN.
13
flow-control
Disables flow control on the port(s).
13
gvrp
Disables GVRP on the port(s).
13
igmp-filtering
profile
Disables IGMP filtering on the port.
13
igmp-group-
limited
Disables IGMP group limitation.
13
igmp-immediate-
leave
Disables IGMP immediate leave on the
port.
13
inactive
Enables the specified interface on the
switch.
13
ingress-check
Incoming traffic on the port(s) is not
checked for VLAN tags.
13
intrusion-lock
Disables intrusion-lock on a port so that
a port can be connected again after you
disconnected the cable.
13
mirror
Disables port mirroring on the port(s).
13
multicast-limit
Disables multicast limit on the port(s).
13
vlan-trunking
Disables VLAN trunking on the port(s).
13
pvid
<1-4094>
The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
13
qos priority
<0 .. 7>
Sets the quality of service priority for an
interface.
13
speed-duplex
full|100-
half|100-
full|1000-full>
Sets the duplex mode (half, full) and
speed (10/100/1000 Mbps) of the
connection on the interface. Selecting
auto (auto-negotiation) makes one port
able to negotiate with a peer
automatically to obtain the connection
speed and duplex mode that both ends
support.
13
Table 85 Command Summary: Interface (continued)
COMMAND
DESCRIPTION
PRIVILEGE