ZyXEL Communications GS-3012F Series - Manual (Page 260)

Chapter 34 IEEE 802.1Q Tagged VLAN Commands
GS-3012/GS-3012F User’s Guide
260
34.4.3 Show GVRP
Syntax:
show vlan1q gvrp
This command shows the switch’s GVRP settings.
An example is shown next.
Figure 161 show gvrp Command Example
34.4.4 Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the switch.
34.4.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to
other switches.
34.5 Port VLAN Commands
You must configure the switch port VLAN settings in config-interface mode.
34.5.1 Set Port VID
Syntax:
pvid
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
sysname# show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
where
= Specifies the VLAN number between 1 and 4094