ZyXEL Communications GS-3012F Series - Manual (Page 252)

Chapter 33 Command Examples
GS-3012/GS-3012F User’s Guide
252
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. Enable this
function to permit VLANs groups beyond the local switch.
An example is shown next.
• Enable the IEEE 802.1Q tagged VLAN command to configure tagged VLAN for the
switch.
• Enable ports one, three, four and five for configuration.
• Enable GVRP on the interface.
Figure 150 gvrp Command Example
33.8.7 ingress-check
Syntax:
ingress-check
Enables the device to discard incoming frames for VLANs that are not included in a port
member set.
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable ingress checking on the interface.
Figure 151 ingress-check Command Example
33.8.8 vlan-trunking
Syntax:
vlan-trunking
Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the switch.
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable VLAN Trunking on the interface.
Figure 152 vlan-trunking Command Example
sysname(config)# vlan1q gvrp
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# gvrp
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# vlan-trunking