ZyXEL Communications GS-3012F Series - Manual (Page 185)

Chapter 25 Access Control
GS-3012/GS-3012F User’s Guide
185
The following table describes the fields in this screen.
25.9 Remote Management
From the Access Control screen, display the Remote Management screen as shown next.
You can specify a group of one or more “trusted computers” from which an administrator may
use a service to manage the switch. Click Access Control to return to the Access Control
screen.
Figure 106 Access Control: Remote Management
The following table describes the labels in this screen.
Table 67 Access Control: Service Access Control
LABEL DESCRIPTION
Services Services you may use to access the switch are listed here.
Active Select this option for the corresponding services that you want to allow to access the
switch.
Service
Port
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port
by typing the new port number in the Service Port field. If you change the default port
number then you will have to let people (who wish to use the service) know the new port
number for that service.
Timeout Type how many minutes a management session (via the web configurator) can be left idle
before the session times out. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value greater than "0" must be
entered.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 68 Access Control: Remote Management
LABEL DESCRIPTION
Entry This is the client set index number. A “client set” is a group of one or more
“trusted computers” from which an administrator may use a service to manage
the switch.
Active Select this check box to activate this secured client set. Clear the check box if
you wish to temporarily disable the set without deleting it.