ZyXEL Communications GS-3012F Series - Manual (Page 250)

Chapter 33 Command Examples
GS-3012/GS-3012F User’s Guide
250
• Enable ports one, three, four and five for configuration.
• Set the BPDU control to tunnel, to forward BPDUs received on ports one, three, four and
five.
Figure 146 interface bpdu-control Command Example
33.8.3 broadcast-limit
Syntax:
broadcast-limit
broadcast-limit
An example is shown next.
• Enable port one for configuration.
• Enable broadcast control.
• Set the number of broadband packets the interface receives per second
Figure 147 broadcast-limit Command Example
33.8.4 bandwidth-limit
Syntax:
bandwidth-limit
bandwidth-limit pir
bandwidth-limit cir
bandwidth-limit egress
An example is shown next.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# bpdu-control tunnel
sysname(config-interface)#
where
Enables broadcast storm control limit on the switch.
Sets how many broadcast packets the interface receives per
second.
sysname(config)# interface port-channel 1
sysname(config-interface)# broadcast-limit
sysname(config-interface)# broadcast-limit 21
where
Enables bandwidth control on the switch.
Sets the maximum bandwidth allowed for outgoing traffic
(egress) or incoming traffic (ingress) on the switch.