ZyXEL Communications GS-3012F Series - Manual (Page 261)

Chapter 34 IEEE 802.1Q Tagged VLAN Commands
GS-3012/GS-3012F User’s Guide
261
Figure 162 port default vid Command Example
34.5.2 Set Acceptable Frame Type
Syntax:
frame-type
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
Figure 163 frame type Command Example
34.5.3 Enable or Disable Port GVRP
Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable
GVRP.
The following example turns off GVRP for ports 1 to 5.
Figure 164 no gvrp Command Example
34.5.4 Modify Static VLAN
Use the following commands in the config-vlan mode to configure the static VLAN table.
sysname(config)# interface port-channel 1-5
sysname(config-interface)# pvid 200
where
=
Specifies all Ethernet frames (tagged and untagged) or
only tagged Ethernet frames.
sysname(config)# interface port-channel 1-5
sysname(config-interface)# frame-type tagged
sysname(config)# interface port-channel 1-5
sysname(config-interface)# no gvrp