ZyXEL Communications GS-3012F Series - Manual (Page 147)

Chapter 20 Queuing Method
GS-3012/GS-3012F User’s Guide
147
Figure 71 Queuing Method
The following table describes the labels in this screen.
Table 50 Queuing Method
LABEL DESCRIPTION
Port This label shows the port you are configuring.
Method Select SPQ (Strict Priority Queuing) or WRR (Weighted Round Robin) scheduling.
Strict Priority Queuing (SPQ) services queues based on priority only. When the
highest priority queue empties, traffic on the next highest-priority queue begins. Q7
has the highest priority and Q0 the lowest.
WRR services queues on a rotating basis based on their queue weight (the number
you configure in the queue Weight field). Queues with larger weights get more
service than queues with smaller weights.
Weight When you select WRR, enter the queue weight here. Bandwidth is divided across the
different traffic queues according to their weights. Queues with larger weights get
more service than queues with smaller weights.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.