ZyXEL Communications GS-3012F Series - Manual (Page 162)

Chapter 22 DHCP Relay
GS-3012/GS-3012F User’s Guide
162
Figure 83 DHCP Relay
The following table describes the labels in this screen.
Table 56 DHCP Relay
LABEL DESCRIPTION
Active Select this check box to enable DHCP relay.
Remote
DHCP
Server 1 .. 3
Enter the IP address of a DHCP server in dotted decimal notation.
Relay Agent
Information
Select the Option 82 check box to have the switch add information (slot number, port
number and VLAN ID) to client TCP/IP configuration requests that it relays to a DHCP
server.
Information This read-only field displays the system name you configure in the General Setup
screen.
Select the check box to add the switch name to the DHCP client requests that the switch
relays to a DHCP server.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields back to your previous configuration.