ZyXEL Communications GS-3012F Series - Manual (Page 208)

Chapter 32 Introducing the Commands
GS-3012/GS-3012F User’s Guide
208
"
The switch automatically logs you out of the management interface after five
minutes of inactivity. If this happens to you, simply log back in again.
32.2.1 Access Priority
• By default, the switch allows multiple concurrent logins. However, no more than ten
concurrent login sessions are allowed.
• If you use the no multi-login command in the configuration mode to disallow
multiple concurrent logins, only one concurrent access to the CLI is allowed via either the
console port or Telnet. Console port access has higher priority.
32.2.2 The Console Port
Connect to the switch’s console port using a terminal emulation software configured to the
following settings:
• VT100 terminal emulation
• 9600 bps
• No parity
• 8 data bits
• 1 stop bit
• No flow control
32.2.2.1 Initial Screen
When you turn on your switch, it performs several internal tests as well as line initialization.
You can view the initialization information using the console port. After the initialization, the
login screen displays (refer to
Section 32.3 on page 209 ).
Figure 119 Initial Console Port Screen
32.2.3 Telnet
Use the following steps to telnet into your switch.
Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
initialize mgmt, ethernet address: 00:13:49:18:00:30
initialize switch, ethernet address: 00:13:49:18:00:31
Initializing switch unit 0...
Initializing VLAN Database...
Initializing IP Interface...
Initializing Advanced Applications...
Initializing Command Line Interface...
Initializing Web Interface...
Restore System Configuration....
Press ENTER to continue...