ZyXEL Communications GS-3012F Series - Manual (Page 254)

Chapter 33 Command Examples
GS-3012/GS-3012F User’s Guide
254
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the IEEE 802.1p quality of service priority as four (4).
Figure 155 qos priority Command Example
33.8.12 name
Syntax:
name
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set a name for the interfaces.
Figure 156 name Command Example
33.8.13 speed-duplex
Syntax:
speed-duplex
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the speed to 10 Mbps in half duplex mode.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# qos priority 4
where
string>
Sets a name for your port interface(s).
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# name Test
where
half|10-
full|100-
half|100-
full|1000-
full>
Sets the duplex mode (half, full) and speed (10/100/1000
Mbps) of the connection on the interface. Selecting auto
(auto-negotiation) makes one port able to negotiate with a
peer automatically to obtain the connection speed and
duplex mode that both ends support.