ZyXEL Communications GS-3012F Series - Manual (Page 213)

Chapter 32 Introducing the Commands
GS-3012/GS-3012F User’s Guide
213
32.8 Using Command History
The switch keeps a list of commands you have entered for the current CLI session. You can
use any commands in the history again by pressing the up (y) or down (z) arrow key to scroll
through the previously used commands and press [ENTER]. Use the history command to
display the list of commands.
Figure 125 CLI: History Command Example
32.9 Saving Your Configuration
After you set the switch settings with the configuration commands, use the write memory
command to save the changes permanently.
Figure 126 CLI: write memory
"
The
write memory
command is not available in User mode.
"
You must save your changes after each CLI session. All unsaved
configuration changes are lost once you restart the switch.
32.9.1 Logging Out
In User or Enable mode, enter the exit or logout command to log out of the CLI. In Config
mode, entering exit takes you out of Config mode and into Enable mode and entering
logout logs you out of the CLI.
sysname> history
enable
exit
show ip
history
sysname>
sysname# write memory