ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 613)

Chapter 45 IP Policy Routing
ZyWALL 2WG User’s Guide
613
2 Select Edit in the Select Command field; type the index number of the rule you want to
configure in the Select Rule field and press [ENTER] to open Menu 25.1 - IP Routing
Policy Setup (see the next figure).
Figure 401 Menu 25.1: IP Routing Policy Setup
The following table describes the fields in this screen.
Menu 25.1 - IP Routing Policy Setup
Rule Index= 1 Active= Yes
Criteria:
IP Protocol = 6
Type of Service= Normal Packet length= 40
Precedence = 0 Len Comp= Equal
Source:
addr start= 1.1.1.1 end= 1.1.1.1
port start= 20 end= 25
Destination:
addr start= 2.2.2.2 end= 2.2.2.5
port start= 20 end= 25
Action= Matched
Gateway Type= IP Address
Gateway addr = 192.168.1.1 Redirect packet= N/A
Type of Service= Max Thruput Log= No
Precedence = 0
Edit policy to packets received from= No
Press ENTER to Confirm or ESC to Cancel:
Table 243 Menu 25.1: IP Routing Policy Setup
FIELD DESCRIPTION
Rule Index This is the index number of the routing policy selected in Menu 25 - IP Routing
Policy Summary.
Active Press [SPACE BAR] and then [ENTER] to select Yes to activate the policy.
Criteria
IP Protocol Enter a number that represents an IP layer 4 protocol, for example, UDP=17,
TCP=6, ICMP=1 and Don't care=0.
Type of Service Prioritize incoming network traffic by choosing from Don't Care, Normal, Min
Delay, Max Thruput or Max Reliable.
Precedence Precedence value of the incoming packet. Press [SPACE BAR] and then [ENTER]
to select a value from 0 to 7 or Don't Care.
Packet Length Type the length of incoming packets (in bytes). The operators in the Len Comp
(next field) apply to packets of this length.
Len Comp Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, Less,
Greater, Less or Equal or Greater or Equal.
Source
addr start / end Source IP address range from start to end.
port start / end Source port number range from start to end; applicable only for TCP/UDP.
Destination