ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 190)

Chapter 10 Wireless LAN
ZyWALL 2WG User’s Guide
190
10.8.1 No Security
"
If you do not enable any wireless security on your ZyWALL, your network is
accessible to any wireless networking device within range.
Figure 92 NETWORK > WIRELESS CARD > Security: None
The following table describes the wireless LAN security labels in this screen.
10.8.2 Static WEP
Static WEP provides a mechanism for encrypting data using encryption keys. Both the AP and
the wireless stations must use the same WEP key to encrypt and decrypt data.
Your ZyWALL allows you to configure up to four 64-bit, 128-bit or 152-bit WEP keys, but
only one key can be used at any one time.
In order to configure and enable WEP encryption, click NETWORK > WIRELESS CARD
> Security > Edit.
Table 60 NETWORK > WIRELESS CARD > Security: None
LABEL DESCRIPTION
Name Type a name (up to 32 printable 7-bit ASCII characters) to identify this security profile.
Security Mode Select None to allow wireless clients to communicate with the access points without
any data encryption.
Apply Click Apply to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.