ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 465)

Chapter 26 Maintenance
ZyWALL 2WG User’s Guide
465
After you see a “restore configuration successful” screen, you must then wait one minute
before logging into the ZyWALL again.
Figure 267 Configuration Upload Successful
The ZyWALL automatically restarts in this time causing a temporary network disconnect. In
some operating systems, you may see the following icon on your desktop.
Figure 268 Network Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default device IP address (192.168.1.1). See
your Quick Start Guide for details on how to set up your computer’s IP address.
If the upload was not successful, the following screen will appear. Click Return to go back to
the Configuration screen.
Figure 269 Configuration Upload Error
26.11.3 Back to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the
ZyWALL to its factory defaults as shown on the screen. The following warning screen
appears.