ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 139)

Chapter 8 WAN Screens
ZyWALL 2WG User’s Guide
139
8.7 Configuring Load Balancing
To configure load balancing on the ZyWALL, click NETWORK > WAN in the navigation
panel. The WAN General screen displays by default. Select Active/Active Mode under
Operation Mode to enable load balancing on the ZyWALL.
The WAN General screen varies depending on what you select in the Load Balancing
Algorithm field.
8.7.1 Least Load First
To configure Least Load First, select Least Load First in the Load Balancing Algorithm
field.
Figure 64 Load Balancing: Least Load First
The following table describes the related fields in this screen.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 33 NETWORK > WAN General (continued)
LABEL DESCRIPTION
Table 34 Load Balancing: Least Load First
LABEL DESCRIPTION
Active/Active
Mode
Select Active/Active Mode and set the related fields to enable load balancing on
the ZyWALL.
Load Balancing
Algorithm
Set the load balancing method to Least Load First.
Time Frame You can set the ZyWALL to get the measured bandwidth using the average
bandwidth in the specified time interval.
Enter the time interval between 10 and 600 seconds.
Load Balancing
Index(es)
Specify the direction of the traffic utilization you want the ZyWALL to use in
calculating the load balancing index.
Select Outbound Only, Inbound Only or Outbound + Inbound.