ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 499)

Chapter 30 LAN Setup
ZyWALL 2WG User’s Guide
499
Figure 294 Menu 3.2: TCP/IP and DHCP Ethernet Setup
Follow the instructions in the next table on how to configure the DHCP fields.
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
DHCP= Server TCP/IP Setup:
Client IP Pool:
Starting Address= 192.168.1.33 IP Address= 192.168.1.1
Size of Client IP Pool= 128 IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
Edit IP Alias= No
DHCP Server Address= N/A
Press ENTER to Confirm or ESC to Cancel:
Table 203 Menu 3.2: DHCP Ethernet Setup Fields
FIELD DESCRIPTION
DHCP This field enables/disables the DHCP server.
If set to Server, your ZyWALL will act as a DHCP server.
If set to None, the DHCP server will be disabled.
If set to Relay, the ZyWALL acts as a surrogate DHCP server and relays requests
and responses between the remote server and the clients.
When set to Server, the following items need to be set:
Client IP Pool:
Starting Address This field specifies the first of the contiguous addresses in the IP address pool.
Size of Client IP
Pool
This field specifies the size, or count of the IP address pool.