2 snmp traps, 3 remote management: snmp, 2 snmp traps 22.14.3 remote management: snmp – ZyXEL Communications ZyXEL ZyWALL 2WG User Manual
Page 400: Figure 236 advanced > remote mgmt > snmp, Table 143 snmp traps
Chapter 22 Remote Management
ZyWALL 2WG User’s Guide
400
22.14.2 SNMP Traps
The ZyWALL will send traps to the SNMP manager when any one of the following events
occurs:
22.14.3 REMOTE MANAGEMENT: SNMP
To change your ZyWALL’s SNMP settings, click ADVANCED > REMOTE MGMT >
SNMP. The screen appears as shown.
Figure 236 ADVANCED > REMOTE MGMT > SNMP
Table 143 SNMP Traps
TRAP #
TRAP NAME
DESCRIPTION
0
coldStart (defined in RFC-1215)
A trap is sent after booting (power on).
1
warmStart (defined in RFC-
1215)
A trap is sent after booting (software reboot).
4
authenticationFailure (defined in
RFC-1215)
A trap is sent to the manager when receiving any SNMP
get or set requirements with the wrong community
(password).
6
whyReboot (defined in ZYXEL-
MIB)
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
6a
For intentional reboot :
A trap is sent with the message "System reboot by user!"
if reboot is done intentionally, (for example, download
new files, CI command "sys reboot", etc.).
6b
For fatal error :
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.