ZyXEL Communications G-2000 Plus - Manual (Page 408)

ZyAIR G-2000 Plus User’s Guide
407 Appendix G
Log Commands
Go to the command interpreter interface (the Command Interpreter Appendix explains how to access
and use the commands).
4 A packet that needed fragmentation was dropped because it was set to Don't Fragment
(DF)
5 Source route failed
4 Source Quench
0 A gateway may discard internet datagrams if it does not have the buffer space needed
to queue the datagrams for output to the next network on the route to the destination
network.
5 Redirect
0 Redirect datagrams for the Network
1 Redirect datagrams for the Host
2 Redirect datagrams for the Type of Service and Network
3 Redirect datagrams for the Type of Service and Host
8 Echo
0 Echo message
11 Time Exceeded
0 Time to live exceeded in transit
1 Fragment reassembly time exceeded
12 Parameter Problem
0 Pointer indicates the error
13 Timestamp
0 Timestamp request message
14 Timestamp Reply
0 Timestamp reply message
15 Information Request
0 Information request message
16 Information Reply
0 Information reply message
Table 150 Sys log
LOG MESSAGE DESCRIPTION
Mon dd hr:mm:ss hostname
src=""
dst=""
msg="" note="" This message is sent by the "RAS" when this syslog is generated. The
messages and notes are defined in this appendix’s other charts.
Table 149 ICMP Notes (continued)
TYPE CODE DESCRIPTION