ZyXEL Communications G-2000 Plus - Manual (Page 154)

ZyAIR G-2000 Plus User’s Guide
153 Chapter 11 Static Route Screens
Figure 63 Static Route
The following table describes the labels in this screen.
Table 48 Static Route
LABEL DESCRIPTION
# Number of an individual static route.
Name Name that describes or identifies this route.
Active This field shows whether this static route is active (Yes) or not (No).
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Gateway This is the IP address of the gateway. The gateway is an immediate neighbor of
your ZyAIR that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as your ZyAIR; over the WAN, the gateway
must be the IP address of one of the remote nodes.
Edit Select a static route index number and then click Edit to set up a static route on the
ZyAIR.
Delete To remove a static route on the ZyAIR, click the radio button next to the static route
index number you want to remove, then click Delete.
11.2.1 Configuring Route Entry
Select a static route index number and click Edit. The screen shown next appears. Fill in the
required information for each static route.