ZyXEL Communications G-2000 Plus - Manual (Page 151)

ZyAIR G-2000 Plus User’s Guide
Chapter 10 Single User Account (SUA) / Network Address Translation (NAT) 150
Figure 61 Trigger Port
The following table describes the labels in this screen.
Table 47 Trigger Port
LABEL DESCRIPTION
# This is the rule index number (read-only).
Name Type a unique name (up to 15 characters) for identification purposes. All characters
are permitted - including spaces.
Incoming Incoming is a port (or a range of ports) that a server on the WAN uses when it sends
out a particular service. The ZyAIR forwards the traffic with this port (or range of ports)
to the client computer on the LAN that requested the service.
Start Port Type a port number or the starting port number in a range of port numbers.
End Port Type a port number or the ending port number in a range of port numbers.
Trigger The trigger port is a port (or a range of ports) that causes (or triggers) the ZyAIR to
record the IP address of the LAN computer that sent the traffic to a server on the WAN.
Start Port Type a port number or the starting port number in a range of port numbers.
End Port Type a port number or the ending port number in a range of port numbers.
Apply Click Apply to save your changes back to the ZyAIR.
Reset Click Reset to begin configuring this screen afresh.