ZyXEL Communications G-2000 Plus - Manual (Page 165)

ZyAIR G-2000 Plus User’s Guide
Chapter 12 Remote Management Screens 164
Figure 70 Remote Management: SNMP
The following table describes the labels in this screen.
Table 54 Remote Management: SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows
all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
Trusted Host If you enter a trusted host, your ZyAIR will only respond to SNMP messages
from this address. A blank (default) field means your ZyAIR will respond to all
SNMP messages it receives, regardless of source.
Trap
Community Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.