ZyXEL Communications G-2000 Plus - Manual (Page 370)

ZyAIR G-2000 Plus User’s Guide
369 Chapter 36 Remote Management
Figure 212
Menu 24.11 - Remote Management Control
TELNET Server: Port = 23 Access = LAN only
Secure Client IP = 0.0.0.0
FTP Server: Port = 21 Access = LAN only
Secure Client IP = 0.0.0.0
Web Server: Port = 80 Access = LAN only
Secure Client IP = 0.0.0.0
SNMP Service: Port = 161 Access = LAN only
Secure Client IP = 0.0.0.0
DNS Service: Port = 53 Access = LAN only
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Menu 24.11 – Remote Management Control
The following table describes the fields in this screen.
Table 125 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service Each of these read-only labels denotes a service or protocol.
Port This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
ZyAIR.
Access Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
Secure Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the
ZyAIR. Enter an IP address to restrict access to a client with a matching IP address.
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
36.1.1 Telnet
You can configure your ZyAIR for remote Telnet access as shown next.