ZyXEL Communications G-2000 Plus - Manual (Page 253)

ZyAIR G-2000 Plus User’s Guide
Chapter 20 Introducing the SMT 252
C
H A P T E R
20
Introducing the SMT
This chapter explains how to access and navigate the System Management Terminal and gives
an overview of its menus.
20.1 SMT Introduction
The ZyAIR’s SMT (System Management Terminal) is a menu-driven interface that you can
access from a terminal emulator through the console port or over a telnet connection. This
chapter shows you how to access the SMT (System Management Terminal) menus, how to
navigate the SMT and how to configure SMT menus.
20.2 Connect to your ZyAIR Using Telnet
The following procedure details how to telnet into your ZyAIR.
1 In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.1” (the default IP address) and click OK.
2 For your first login, enter the default password “1234”. As you type the password, the
screen displays an asterisk “*” for each character you type.
Figure 115 Login Screen
Password : xxxx
3 After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period)
after you log in, your ZyAIR will automatically log you out. You will then have to telnet into
the ZyAIR again. You can use the web configurator or the CI commands to change the
inactivity time out period.
20.2.1 Entering Password
The login screen appears after you press [ENTER], prompting you to enter the password, as
shown next.
For your first login, enter the default password “1234”. As you type the password, the screen
displays an asterisk “*” for each character you type.