Xerox 50 - Manual (Page 83)

DOCUMENT CENTRE CS 50 USER GUIDE 4–11 BASIC COPYING
1
2
3
5
6
7
4
Auto%
The Auto% option automatically reduces or
enlarges the copy, based on the size and
orientation of the document and the paper supply
selected. This option is applied only to standard
size documents.
KEY POINT: Select Auto% when the document
and the copy paper are different sizes.
KEY POINT: A factory default setting of 2 mm
edge erase applies to making copies. This setting
cannot be altered.
The copy image will be reduced or enlarged in the
same proportions for X (horizontal) and Y
(vertical) directions.
KEY POINT: The X and Y directions are always
determined in reference to the registration arrow,
located around the Document Glass, Figure 13.
The X direction is always along the long edge of
the Document Glass, and the Y direction is along
the short edge of the Document Glass. The X and
Y direction references on the Document Glass
remain the same, regardless of the document
orientation (long edge registration or short edge
registration).
NOTE: The Auto Paper option in Paper Supply is
not available when Auto% is selected.
Setting basic options
On the Basic Copying Tab, select the desired
Reduce/Enlarge option, as in Figure 14.
Figure 13: Document Glass directions
Figure 14: Reduce/Enlarge options on the
Basic Copying Tab
X Direction
Y Direction