Xerox 50 - Manual (Page 191)

DOCUMENT CENTRE CS 50 USER GUIDE 9–5 PAPER
1
3
4
5
6
7
9
Loading stock
Using paper
The front and back surfaces of a piece of paper
differ slightly. Therefore, one side is preferred as
the side to image when copying to one side only,
or the side to image first if copying to two sides.
This side is referred to as the Preferred Printing
Side, or the Wire Side. The other side is referred
to as the Nonpreferred Printing Side, or the Felt
Side.
Some ream wrappers mark this Preferred
Printing Side with an arrow. If the arrow is not
present, turn the ream over so the seam is facing
up.
Load the paper into Paper Trays 1, 2, 3, and 4 with
the preferred printing side down. With the wrapper
seam facing up (illustrated in Figure 3), remove
the paper from the wrapper and load without
turning it.
Load the paper into Paper Tray 5 with the
preferred printing side up. With the seam facing
down, remove the paper from the wrapper and
load it without turning it.
The sheet capacity of the tray varies with the
paper weight that is loaded in the tray. Refer to the
“Paper Usage” section in this chapter for the
recommended paper stock selections, or refer to
the Recommended Materials List and the Color
Materials Usage Guide.
Figure 3: Opening a ream of paper with seam
side up