Xerox 50 - Manual (Page 228)

ACCESSORIES 12–4 DOCUMENT CENTRE CS 50 USER GUIDE
2
3
4
5
6
7
12
2 If you are changing paper sizes, perform the
following:
a. Remove all paper in the tray.
CAUTION: Handle the paper and the Paper
Guide carefully so you do not break the black
plastic sensor actuators on the guide.
b. Remove the metal Paper Guide by pulling it
straight up (Figure 5).
c. Align the tabs on the bottom and top of the
guide with the slots on the bottom and top of
the tray for the new size. Push the guide
firmly into the slots until it is secure.
3 Load the paper. Ensure that the paper is aligned
evenly and tightly against the right side of the tray.
4 Close the HCF paper tray.
When you close the HCF, the elevator rises and
positions the paper for use.
5 If you are in printer mode and the HCF is set as
your default paper tray, change the necessary
printer drivers options at the client workstation.
Figure 5: The HCF Paper Guide