Xerox 50 - Manual (Page 123)

DOCUMENT CENTRE CS 50 USER GUIDE 5–27 ADDED FEATURES
1
2
3
4
6
7
5
Variable Erase for edges
The Variable Erase option, illustrated in Figure 29,
enables the copier/printer to vary the amount of
erasure from 0 to 50 mm in 1 mm increments. The
same amount of erasure is applied to both top and
bottom edges or right and left edges of the
document.
KEY POINT: If your document contains an image
area that extends to the edges of the document,
and you do not want any of it to be deleted, use
the Variable Erase arrow buttons to set the erase
value to zero. Select the Margin Shift feature, Auto
Center option, from the Added Features tab.
Reduce the image until the entire area is
captured. If you do not want to reduce the image,
copy it to larger paper. For example, copy an 8.5
x 11 in. image onto 11 x 17 in. paper with the
options described above selected.
The Center Area Erase option allows you to
remove the shadow caused by the center binding
of bound documents when they are copied. The
factory default setting for Center Erase is 0 (zero).
Select the up arrow to increase the amount of
erasure or the down arrow to decrease the
amount of erasure.
NOTE: Keep the following notes in mind when
using Center Area Erase:
•
Do not use Center Area Erase with the
following features:
– Multiple-Up
– Repeat Image
– Poster Mode
•
The Center Area Erase setting in the Variable
Erase feature is the same as the center erase
setting of Book Copying.
•
For some original image sizes, Center Area
Erase does not occur exactly in the center of
the output image.
Figure 29: Variable Erase screen