Xerox 50 - Manual (Page 60)

MAKING COPIES 3–2 DOCUMENT CENTRE CS 50 USER GUIDE
2
3
4
5
6
7
3
Power on and off
Switching the power on
Press the Power Switch to the On position to
switch the copier/printer on. A message will
display asking you to wait.
After the Power Switch is pressed to On, the
copier/printer takes approximately eight minutes
to come to a Ready to Make Copies condition.
Switching the power off
Press the Power Switch to the Off position to
switch the copier/printer off, as in Figure 1. The
Touch Screen will go dark.
Allow the copier/printer to remain off for
approximately 30 seconds before switching it
on again.
NOTE: If the Start button is pressed during
warm-up, the copier/printer will automatically start
the job after it comes to the Ready state. Pressing
Stop displays a message allowing you to either
cancel the job by pressing Clear, or continue the
job by pressing Start.
CAUTION: The Fuser Roll remains in a cammed-
up position if power to the copier/printer is
interrupted while the copier/printer is in use. If the
Fuser Roll remains in the cammed-up position for
a prolonged period of time, the Fuser Roll can be
damaged and copy quality defects can occur. To
prevent any damage, the copier/printer should be
powered on and a copy made as soon as the
power is restored. The Fuser Roll will not be
released from the cammed-up position until the
power is restored, the Power Switch is in the On
position, and the Start button is pressed again.
Figure 1: Power Switch - Off Position