Xerox 50 - Manual (Page 237)

DOCUMENT CENTRE CS 50 USER GUIDE 12–13 ACCESSORIES
1
3
4
5
6
7
12
Clearing a stapler jam
1 For a simple jam, remove the set with the jammed
staples from the stapler. Insert a sheet under the
staple head to cause the stapler to eject the
jammed staple.
2 If the set itself is jammed, remove the staple
cartridge, as described in the “Adding Staples”
section. Then pull out the jammed set.
Clear the jammed staple and reinsert the cartridge
or insert a new cartridge.
Troubleshooting
If you suspect a problem with the Convenience
Stapler, perform the following steps in the order
listed.
1 Ensure that the stapler cover is completely closed.
2 Check the power cord and power switch on the
printer/copier to ensure that it is plugged in and
powered on.
3 Check the power cord for the stapler to ensure
that it is plugged in (Figure 7).
4 Perform the procedure for “Clearing a stapler jam”
found earlier in this chapter.
5 If the stapler is still not operating correctly, call for
assistance.