Ricoh 170 / 180 - Manual (Page 79)

3. Change the setting of digit 3. Press 3 us-
ing the ten keypad .
KPAD/Y/j k
SWITCH 08:0000 1100
4. Finish: Press the Yes key, then press
the Function key.
Programming the Authorized Senders
1. Press the Function key and
6,2,2,2,2,7,1 using the ten keypad then
press the Yes key.
SETTING? Y/j k
PRINT LISTj/SEARCHk
❐
At this time, you can print an Authorized Reception
List by pressing the
j key, then press the Start key.
2. Press the Yes key. RTI/CSI ABC j k
llllllllllllllllll
3. Type in an RTI or CSI.
Example: XYZ.CO.
RTI/CSI ABC j k
XYZ.CO.llllllllllll
4. Press the Yes key. If the display is not
as opposite, press the Yes key again.
RTI/CSI Y/N
STORE AS WILD CARD?
5. Either: RTI/CSI ABC j k
llllllllllllllllll
❐ Store this RTI as a Wild card:
Press the Yes key.
❐ Otherwise: Press the No key.
6. Either:
❐ Store another RTI/CSI: Go to step 2.
❐ Finish: Press the Function key.
Editing the Authorized Senders
1. Press the Function key and
6,2,2,2,2,7,1 using the ten keypad then
press the Yes key.
SETTING? Y/j k
PRINT LISTj/SEARCHk
❐
At this time, you can print an Authorized Reception
List by pressing the
j key, then press the Start key.
2. Press the Yes key. RTI/CSI ABC
llllllllllllllllll
Digit 3
0: Accept incoming messages only from
specified senders.
1: Accept all incoming messages except those
from specified senders.
Label input and editing: see page 100.
RECEPTION
68