Replacing paper, Paper cycling, Procedure – Ricoh 170 / 180 User Manual

Page 104

REPLACING PAPER

When"

REPLACE PAPER

" is displayed, the roll is empty or it is not set

correctly. Install a new roll or reset it .

Procedure

1. Lift the catch to unlock the printer cover.

Then, hold the paper guides and open
the cover.

2. Unpack the new thermal paper and in-

cert the rod into the paper roll as shown,
then set the roll into the machine. (Hold
the roll in a direction so that it rolls away
from you when pulled upwards.)

NOTE: Make sure the ends of the rod fit
intothe paper guides.

3. Pull out the leading edge until you can

see it and feed the paper between the
roller and the cover until it appears out-
side the back of the machine.

NOTE: Make sure that there is no slack
paper inside the machine and the
transparent strip that prevents paper
curling is above the copy tray

4. Close the printer paper cover until it audi-

bly locks into place.

5. The machine will tear off the excess paper. Press the Start key.

NOTE: If you forget this step, you can not receive or copy.

PAPER CYCLING

If "

PUSH START

" or "

UNABLE USE PRINTER

" is displayed, press the

Start key.

The paper will cycle and any excess will be automatically cut off.

INT

AINING

CHINE